Printronix Network Interface Card - Manual (Page 191)

NDPS Configuration (Netware 4.11 And Above)
191
Wait two minutes and then check your PSERVER to see if the
appropriate printer is being serviced. The printer should display a
message such as Waiting for job. At this point, the NIC knows to
receive any jobs this PSERVER.NLM has to send to it through the
defined printer.
NDPS Configuration (Netware 4.11 And Above)
Overview
In 1998, Novell released a new printing system designed to make
network administration of printers easier and more fully functional.
This system is called Novell Distributed Print Services (NDPS), and
can be used with Novell Netware 4.11 and above along with the
supporting software on clients. This section gives high-level
instructions to install and use NDPS with the printer. These
instructions assume that you understand NDPS architecture well
enough to be able to use these instructions along with Novell's
instructions to install NIC into NDPS. See Novell’s documentation
to understand terms not defined here.
The drivers used with the Printronix printer can be found at
www.printronix.com. For a driver to be automatically downloaded to
a Windows machine when an NDPS printer is installed, the driver
must be installed into the NDPS Broker Resource Management
Service. See Novell’s documentation for more information.
The NIC can be installed into NDPS using the Novell Printer
Gateway feature of NDPS. Within this Novell Printer Gateway,
various printer connection modes can be used to install the printer
into NDPS. The ones described here are:
• Setup using Forward Jobs to a Queue Mode
• Setup using LPR Mode
• Setup using RPRINTER Mode