Printronix Network Interface Card - Manual (Page 324)

Chapter 15 Complete Command List
324
set ifc
Example: set ifc up|down
Set state of the specified network physical interface up or
down. is the interface number for the NIC device.
set logpath name
Example: set logpath l1 name pagecount
Change the current name of the logpath () to a new
name as indicated by . These names are case
sensitive.
set logpath > type [[-]job] [[-]user]
[[-]cksum] [[-]printer] [[-]ioport]
Example: set logpath l2 type job user printer pgcnt
Establish the type of printer and print job logging to be done
within this . The options are:
job Job ID, username, etc.
user User ID along with three messages per job
about start and finish.
cksum 16-bit checksum value to confirm integrity of
data printed.
printer For special printer feedback.
ioport Printer error messages determined through
the parallel port pins.
set logpath port port>|email|syslog
Example: set logpath l3 port 2000
Determine where the log information should be sent for a print
job or attached printer. The choices are:
TCP-port TCP port number ranging from 1024 to
65000.
email Particular user's email address. This address
is set using the set sysinfo email
emailname@IPaddress or
[email protected] command.