Promise Technology SMARTSTOR NS4300N - Manual (Page 179)

Chapter 8: Troubleshooting
169
The time needed to check and rebuild the File System depends on the
amount of data on the SmartStor. The process can take anywhere from 10
minutes to 2 hours.
Checking the Event Log in PASM
To view the Event Log in PASM:
To check Enclosure status:
1. Start PASM.
See “PASM in your Browser” on page 106.
Or see “PASM in SmartNAVI” on page 107.
2. In the Tree, click the + beside the Management icon.
3. Click the Event Log icon.
The Event Log displays. See Figure 4.
Figure 4. The PASM Event Log
4. Check the Event Log for reports of disk drive failure or other problems.
Warning
Do not disconnect the power or shut down the SmartStor while the
check/rebuild is running!