Paradyne BitStorm IP DSLAM 1900 - Manual (Page 25)

1. BitStorm 1900 IP DSLAM
1900-A2-GN20-00 BitStorm 1900 Installation and Maintenance Guide 1-9
Passes VLAN Tagged Frames
The BitStorm 1900 is capable of passing 802.1Q tagged Ethernet
frames of 1522 bytes. To implement a VLAN solution, a 802.1Q
tagging switch must exist upstream. Also, an 802.1Q tagging switch or
device must be present on the customer end of the CPE modem.
WAN Interface Cards
The BitStorm 1900 supports the following WAN interface:
• MIU (Management Interface Card) – supports 10306 and 10224
modem cards
MIU SNMP Functionality
The MIU provides remote monitoring and configuration functionality
via SNMP (Simple Network Management Protocol). Through the
SNMP agent, users can remotely manage and configure modem
settings and monitor the performance statistics of all modems in the
BitStorm 1900 system.
The MIU SNMP agent supports the SNMPv1/RFC 1157 protocol and
supports RFC 1213 MIB II interface groups and the RFC 1493 Bridge
MIB. The MIU SNMP agent also includes an EtherLoop private MIB.
In order to manage the SNMP agent, the user must load our private
MIB into the user’s SNMP Network Manager using the procedure
accompanying the specific Network Management Software (i.e., HP
Openview, etc.).
A list of all supported MIBs and the private MIB can be found in
document 1900-A2-GK40, BitStorm 1900 IP DSLAM Supported SNMP
MIBs. This document and private MIBs can be downloaded from the
Paradyne website at www.paradyne.com.