Paradyne BitStorm IP DSLAM 1900 - Manual (Page 110)

2. BitStorm 1900 Installation and Testing
2-94 BitStorm 1900 Installation and Maintenance Guide 1900-A2-GN20-00
Step Procedure (continued)
14.) From this screen changes to the Community Name ,
Current Poll Interval , and Set Trap Targets
can be made. Refer to the following table as a guide for these
settings. If there are no changes, press
< E n t e r > to continue
to the next item.
Setting Description
Community Name The Community Name is used by SNMP V1
as a minimum security control tool much like a user
ID and/or password.
• For this field, enter an identifier of up to 15 alpha
characters.
Current Poll Interval The Current Polling Interval
provides the ability to set the poll interval in number
of seconds. The SNMP Agent polls the modems
every n seconds for trap conditions (alarms).
(n=how often the equipment is polled.)
• The acceptable range is 5 to 60 seconds
(inclusive).
• To disable the polling, set the poll interval to 0.
Set Trap Targets Set Trap Targets is used to set the IP
Address of the Network Management Stations
where the SNMP Traps are designated to.
• Up to 3 Trap Targets can be set.