PIONEERPOS AT Commands G24-LC - Manual (Page 85)

Chapter 3: AT Commands Reference
April 15, 2008 G24-L AT Commands Reference Manual 3-21
+CCWA, Call Waiting Command
This command controls the Call Waiting supplementary service, including the settings and the
queries of the G24-L and the network. When the Call Waiting indication is enabled by the G24-L
and there is a waiting call, a +CCWA: indication is sent from the G24-L to the terminal.
Note: The G24-L supports only one of the services at a time: Voice, Data or Fax. Multiparty is
a voice-only functionality.
A CCWA indication is sent to the terminal only during a voice call-waiting event. A
CCWA indication is not sent for a fax/data call during in a voice session.
+CCWA Indication
When a call-waiting indication is enabled by the G24-L (=1), the following unsolicited
indication is sent to the terminal from the G24-L:
+CCWA:,,,[][,]
Action Syntax Response Remarks
Set +CCWA=[[,
[,]]]
OK
If =2 and the
command succeeds:
+CCWA:
,
[+CCWA:
,
[...]]
OK
The Set command enables/disables the
Call-Waiting indication in the G24-L and
in the network. Activation, deactivation
and status query are supported.
Note: When the parameter is set
to 2 (network query), the
parameter is ignored. This means
that no enable/disable action is
performed while querying the
network.
Read +CCWA? +CCWA:
OK
The Read command returns the
enable/disable status of the call waiting
indication in the G24-L ().
Test +CCWA=? +CCWA: (list of
supported s)
The Test command returns values
supported by the G24-L as a compound
value.