PIONEERPOS AT Commands G24-LC - Manual (Page 77)

Chapter 3: AT Commands Reference
April 15, 2008 G24-L AT Commands Reference Manual 3-13
The following table shows a detailed description for the D> commands.
Note: Current used memory (phone book) set/read is done through the memory command
+CPBS=/+CPBS? respectively.
The following table shows the D> parameters.
Example
AT+CPBS="me" //Phone flash memory
OK
AT+CSCS="ASCII" //ASCII characters
OK
AT+CPBW=1,"035659090",129,"VoiceMail"
OK
AT+CPBR=1
+CPBR: 001,"035659090",129,"VoiceMail"
OK
atd>"VoiceMail"; //Phonebook by name
OK
OK
ath
NO CARRIER
OK
Command Detailed Description
D>[;] Originates a call to a phone number with the corresponding alphanumeric field
. The Current Phone Book (Set by +CPBS) is searched for the entry that
begins with the alphanumeric pattern .
D>mem[;] Originates a call to a phone number in memory (phone book) mem and stored in entry
location . Available memories may be queried with Select Phone Book
Storage Test command +CPBS=?.
Note: This command does not change the used memory set.
D>[;] Originates a call to a phone number from entry location in the Current Phone
Book (Set by +CPBS).
Table 3-5: D> Parameters
Description
<"alpha"> String type value, which should be equal to an alphanumeric field in a phone book
entry. The used character set should be the one selected with Select Terminal
Character Set +CSCS. is case-sensitive, and should be placed in quotes
("alpha").
This parameter is also called "speed dial location". It is an integer type memory
location. should be in the range of locations available in the memory used.
This parameter is not case-sensitive.