PIONEERPOS AT Commands G24-LC - Manual (Page 99)

Chapter 3: AT Commands Reference
April 15, 2008 G24-L AT Commands Reference Manual 3-35
The following table shows the AT+CSNS parameters.
Note: Any mobile-terminated call lacking bearer capability information is handled according to
the current CSNS setting.
When is set to data service, the parameter values set with the +CBST command
are used (Refer to
“+CBST, Select Bearer Service Type” on page 3-31 ). If the +CBST
parameter is set to a value that is not applicable to single numbering calls, the G24-L
maps the value to the matching one, according to the Mapping Table (
Table 3-16 ).
The selected in conjunction with value ’2’ setting replaces
setting in MS non-volatile memory of the bearer or teleservice to be used when mobile
terminated single numbering scheme call is established. Selected is effective
until new CSNS set command is issued. After power cycle, setting in MS
non-volatile memory returns to be effective ( selected in conjunction with
value ’2’ or default ).
If CSNS set command is issued in conjunction with value ’0’ (one shot), then
selected is effective until any call indication is received (RING, CRING, CLCC,
and so on). Afterwards, stored in MS non-volatile memory, returns to be
effective.
If CSNS set command is issued in conjunction with value ’1’, then selected
CSNS is effective until new CSNS set command is issued or until next power
cycle.
If CSNS set command is issued without parameter , the value of repeated is
assumed to be ’0’.
Table 3-15: +CSNS Parameters
Description
CSNS mode:
0 - Voice (default)
2 - Fax (TS 62)
4 - Data
Defines for how long to save the new setting:
0
One shot (new setting is not saved)
1 CSNS mode is saved until new +CSNS set command is issued or next power
cycle, whichever occurs first.
2 CSNS mode is saved until new +CSNS set command is issued. The CSNS
mode will be stored in non-volatile memory and will be effective after power
cycle.