PIONEERPOS AT Commands G24-LC - Manual (Page 218)

Hardware Information
3-154 G24-L AT Commands Reference Manual April 15, 2008
The following table shows the +MPCMC parameters.
Example
AT+MPCMC=?
+MPCMC:(0-1)
OK
AT+MPCMC=1
OK
AT+MPCMC?
+MPCMC: 1
OK
AT+MPCMC=0
OK
AT+MPCMC?
+MPCMC: 0
OK
Command
Type Syntax Response/Action Remarks
Set +MPCMC= OK
or:
+CME ERROR:
The Set command is used for setting
the PCM clock configuration.
Read +MPCMC? +MPCMC:
OK
or:
+CME ERROR:
The Read command returns the current
PCM clock value.
Test +MPCMC=? +MPCMC: (list of
supported s)
OK
The Test command returns the possible
values.
Table 3-99: +MPCMC Parameters
Description
0 Non-continuous PCM clock.
1 Continuous PCM clock.
Before the AT+MPCMC command is set for the first time,
this value is 0.
Power-up is according to the flex.