PIONEERPOS AT Commands G24-LC User Manual
Page 52
AT Commands Summary
1-22
G24-L AT Commands Reference Manual
April 15, 2008
E
This command defines whether the G24-L echoes the characters
received from the user, (whether input characters are echoed to
output).
X
This command defines the data adaptor response set, and the
CONNECT result code format.
Sn
This command reads/writes values of the S-registers, and includes
registers 1-49, 94, 96 (Audio) and 102 (Sleep mode).
\S
This command displays the status of selected commands and
S-registers.
\G
This command sets the use of the software flow control.
\J
This command adjusts the terminal auto rate.
\N
This command displays the type of link.
+CBAND
This command is supported for backward compatibility only, and
has no effect.
?
This command displays the most recently updated value stored in
the S-register.
&F
This command restores the factory default configuration profile.
Z
This command resets the default configuration.
Sleep Mode Commands
S24
This S-parameter activates/disables the Sleep mode. If the parameter
value is greater than 0, it represent the number of seconds till the
G24-L enters sleep mode.
S102
This S-register sets the value of the delay before sending the data to
the terminal.
+MSCTS
This command defines the behavior of the CTS line when the G24-L
is in Sleep mode.
Error Handling Commands
+CMEE
This command enables/disables the use of result code +CME
ERROR:
functionality of the G24-L.
+CEER
This command returns an extended error report containing one or
more lines of information text, determined by the manufacturer,
providing the reasons for the
call-clearing errors.
User Interface
+CRSM
This command provides limited access to the Elementary Files on
the SIM.
&V
This command displays the current active configuration and stored
user profiles.
&W
This command stores the user profile.
Table 1-1: AT Commands (Cont.)
AT Command
Description
Page