PIONEERPOS AT Commands G24-LC User Manual
Page 54
AT Commands Summary
1-24
G24-L AT Commands Reference Manual
April 15, 2008
TCP/IP Commands
+MIPCALL
This command creates a wireless PPP connection with the GGSN,
and returns a valid dynamic IP for the G24-L.
+MIPOPEN
This command causes the G24-L to initialize a new socket and open
a connection with a remote side.
+MIPODM
This command causes the G24-L to initialize a new socket in Online
Data Mode and open a connection with a remote side.
+MIPCLOSE
This command causes the G24-L to free the socket accumulating
buffer and disconnect the G24-L from a remote side.
+MIPSETS
This command causes the G24-L to set a watermark in the
accumulating buffer. When the watermark is reached, data is pushed
from the accumulating buffer into the protocol stack.
+MIPSEND
This command causes the G24-L to transmit the data that the
terminal provides, using an existing protocol stack.
+MIPPUSH
This command causes the G24-L to push the data accumulated in its
accumulating buffers into the protocol stack.
+MIPFLUSH
This command causes the G24-L to flush (delete) data accumulated
in its accumulating buffers.
+MIPRUDP
This unsolicited event is sent to the terminal when data is received
from the UDP protocol stack.
+MIPRTCP
This unsolicited event is sent to the terminal when data is received
from the TCP protocol stack.
+MIPSTAT
This unsolicited event is sent to the terminal indicating a change in
link status.
+MIPXOFF
This unsolicited event is sent to the terminal to stop sending data.
+MIPXON
This unsolicited event is sent to the terminal when the G24-L has
free memory in the accumulating buffer.
+MIPCONF
Configure Internal TCP/IP stack.
+MPING
This command will allow verifying IP connectivity to another
remote machine (computer) by sending one or more Internet Control
Message Protocol (ICMP) Echo Request messages.
+MPINGSTAT
This is the unsolicited response that the G24-L sends to the terminal
to inform of ping execution status update and provide summary
statistics of ping request when ping request execution is completed.
+MSDNS
This command sets/reads DNS IP address for each socket.
+MIPCFF
This command sets the Filtering List..
NOP Compatible
Ignored (Compatible Only) Commands
%C
This command is supported for backward compatibility only, and
has no effect.
Table 1-1: AT Commands (Cont.)
AT Command
Description
Page