PIONEERPOS AT Commands G24-LC - Manual (Page 418)

AT Commands Alphabetical Summary
A-16 G24-L AT Commands Reference Manual April 15, 2008
N This command is supported for
backward compatibility only, and
has no effect. Page 3-304
O This command returns a phone to
the Online Data mode and issues
a CONNECT or CONNECT
result code. Page 3-33
P This command is supported for
backward compatibility only, and
has no effect. Page 3-304
Q This command determines
whether to output/suppress the
result codes. Page 3-191
RING This unsolicited event is received
when an incoming call (voice,
data or fax) is indicated by the
cellular network. Page 3-17
S102 This S-register sets the value of
the delay before sending the data
to the terminal. Page 3-203
S24 This S-parameter
activates/disables the Sleep
mode. If the parameter value is
greater than 0, it represent the
number of seconds till the G24-L
enters sleep mode. Page 3-202
S94 This S-parameter represents the
Boolean status, On/Off, of the
sidetone feature. Page 3-161
S96 This S-parameter represents the
Boolean status, On/Off, of the
echo cancelling feature in the
handsfree. Page 3-162
Sn This command reads/writes
values of the S-registers, and
includes registers 1-49. Page 3-194
T This command is supported for
backward compatibility only, and
has no effect. Page 3-304
V This command determines the
response format of the data
adapter and the contents of the
header and trailer transmitted
with the result codes and
information responses. Page 3-190
Table A-1: AT Commands (Alphabetical) (Cont.)
AT Command Description Page