PIONEERPOS AT Commands G24-LC - Manual (Page 271)

Chapter 3: AT Commands Reference
April 15, 2008 G24-L AT Commands Reference Manual 3-207
The following table shows the +CMEE parameters.
Command
Type Syntax Response/Action Remarks
Set AT+CMEE=[] OK
or:
+CME ERROR:
The Set command enables or disables the
use of result code +CME ERROR: as
an indication of an error relating to the
functionality of the G24-L.
Read AT+CMEE? +CMEE:
OK
The Read command returns the current
setting format of the result code.
Test AT+CMEE=? +CMEE: (list of
supported s)
OK
The Test command returns values
supported by the terminal as a compound
value.
Table 3-139: +CMEE Parameters
Description
0 Disable the +CME ERROR: result code and use ERROR.
1 Enable the +CME ERROR: or +CMS ERROR: result codes and
use numeric values or +STK ERROR: result codes and use numeric
values.
2
Enable the +CME ERROR: or +CMS ERROR: result codes and
use verbose values or +STK ERROR: result codes and use numeric
values.
The default value is 0.