PIONEERPOS AT Commands G24-LC - Manual (Page 191)

Chapter 3: AT Commands Reference
April 15, 2008 G24-L AT Commands Reference Manual 3-127
This command is a non-basic command, which means that the G24-L module rejects the
command with an appropriate error message when the SIM is not present and/or the phone is in
lock state.
Command Type Syntax Response/Action Remarks
Set +MFS=
[,]
OK
or:
+CME ERROR:
This command enables you to change
and store in Flex the new values of
Frequency of Search and
Search mode .
If only the value is given, then
the Set command is interpreted as
follows:
• Store new value. The
value remains unchanged.
If and values are
given, then the Set command is
interpreted as follows:
• Store new and
values.
Otherwise, an error message is sent to
the DTE.
Note: If the phone is not registered,
then a set operation of Search
mode to Manual is refused and
ERROR is sent to the DTE.
Read +MFS? +MFS: ,
OK
or:
+CME ERROR:
The Read command returns the current
settings for values of and
.
Test +MFS=? +MFS: (List of
supported ,(List
of supported s)
OK
or:
+CME ERROR:
The Test command returns the possible
and values.