PIONEERPOS AT Commands G24-LC - Manual (Page 134)

Phone Books and Clock
3-70 G24-L AT Commands Reference Manual April 15, 2008
• = 0 - Do not show any number on next +CPIN insertion command
• = 1 - Default (equals 1) is set to = 1
If only a pair of and values are given, then the Set command is interpreted as
follows:
• = 0, = any valid indexSet mode for given index to 0
• = 1, = any valid indexSet mode for given index to 1
If only , and values are given, then the Set command is interpreted as
follows:
• Store in of EFmsisdn in the SIM, the . Since no was given,
corresponding will be identical to the already stored in this . Also
store the value for this .
If all parameters are given, then the Set command is interpreted as follows:
• Store in of EFmsisdn in the SIM, the and corresponding . In case
an empty string was given as the parameter, the corresponding will be an
empty string. Also store the value for this .
Note: Only the last whose mode was set to 1 will be sent to the DTE.
Command Type Syntax Response/Action Remarks
Set +MCSN=
[,[,er>[,]]]
OK
or:
+CME ERROR:
See above
Read +MCSN? +MCSN:
OK
or:
+CME ERROR:
The Read command queries the current
settings for the of the storage
place in which the is equal to
1. If no index has its set to 1,
then the response will be
equal to 0.
Test +MCSN=? +MCSN: (list of
supported
s),(list of
supported es)
OK
or:
+CME ERROR:
The Test command returns the possible
and values.