PIONEERPOS AT Commands G24-LC - Manual (Page 403)

April 15, 2008 G24-L AT Commands Reference Manual A-1
Appendix A: Reference Tables
This appendix contains the following sections:
• AT Commands Alphabetical Summary, below
• Character Set Table CS1: (GSM -> UCS-2), Page -17
• Character Set Table CS2: (ASCII <-> UTF-8), Page -21
• Character Set Table CS3: (UCS-2 <-> UTF-8), Page -21
• Character Set Table CS6: (UCS-2 Full Table), Page -21
• Character Set Table CS7: (ASCII table), Page -22
Note: Character Set Table CS6: (UCS-2) is provided on CD due to its size.
AT Commands Alphabetical Summary
The following table contains an alphabetical list of all the G24-L AT commands.
Table A-1: AT Commands (Alphabetical)
AT Command Description Page
$ This command displays a list of
all the AT commands supported
by the G24-L. Page 3-7
%C This command is supported for
backward compatibility only, and
has no effect. Page 3-304
&C This command determines how
the state of the DCD line relates
to the detection of the received
line signal from the distant end. Page 3-136
&D This command determines how
the G24-L responds when the
DTR (Data Terminal Ready)
status is changed from ON to
OFF during the online data state. Page 3-138
&F This command restores the
factory default configuration
profile. Page 3-198