PIONEERPOS AT Commands G24-LC - Manual (Page 369)

April 15, 2008 G24-L AT Commands Reference Manual 4-1
Chapter 4: Using the Commands
Setting Up the G24-L (Power On and Initial Actions)
There are three phases of connectivity for the G24-L:
• Init General.
In this phase, the G24-L is asked to provide basic information which ensures that the phone
is functioning properly.
• Enabling the SIM.
• Registering the SIM on a network in order to see that wireless access is functioning properly.
After these three phases are completed, G24-L is ready for action and you can send/receive voice
calls, circuit switched data and GPRS.
The following figures show the phone state transactions:
Figure 4-1: Phone State Transactions
Init-General
Init Phone
Ready No Coverage
Voice CSD Data GPRS
Communication=OK, ID is known
Sim card=OK, Registered to network
Coverage Indication
Remote/Local
Connected/Disconnected
Remote/Local
Connected/Disconnected