PIONEERPOS AT Commands G24-LC - Manual (Page 306)

GPRS
3-242 G24-L AT Commands Reference Manual April 15, 2008
D*99, Request GPRS Service "D"
This command enables the ME to perform the actions necessary for establishing communication
between the terminal and the external Packet Data Network (PDN).
The ITU V.25ter 'D' (Dial) command causes the ME to enter the ITU V.25ter Online Data state
and together with the terminal, to start the specified layer 2 protocol. The ME returns CONNECT
to confirm acceptance of the command prior to entering the ITU V.25ter Online Data state. No
further commands may follow on the AT command line.
The detailed behavior after the Online Data state has been entered is dependent on the PDP type,
and is described briefly. GPRS attachment and PDP context activation procedures may take place
prior to, or during the PDP startup if they have not already been performed using the +CGATT
and +CGACT commands.
When the layer 2 protocols have terminated, either as a result of an orderly shut down of the PDP
or an error, the ME enters the ITU V.25ter command state and returns the NO CARRIER final
result code.
If is supported and provided, the ME automatically sets up a virtual call to the
specified address after the PDP context has been activated.
If and are supported, the +CGDCONT, +CGQREQ and other such commands may
then be used in the modem initialization AT command string to set values for PDP type, APN,
QoS and so on.
If is not supported, or is supported but omitted, the ME uses a layer 2 protocol appropriate
to the PDP type.
If is not supported, or is supported but omitted, the ME attempts to activate the context
using one of the following:
• Any information provided by the terminal during the PDP startup procedure. For example,
the terminal may provide a PDP type and/or PDP address to the ME.
• A prior knowledge, for example, the ME may implement only one PDP type.
Using the "Empty PDP type" No PDP address or APN is sent in this case and only one PDP
context subscription record is present in the HLR for this subscriber.
This command may be used in both normal and modem compatibility modes.
Command
Type
Syntax Response/Action
Set ATD*
[*[][*[]
[*[]]]]#
CONNECT
or:
ERROR