PIONEERPOS AT Commands G24-LC - Manual (Page 270)

Modem Configuration and Profile
3-206 G24-L AT Commands Reference Manual April 15, 2008
The following table shows the +MSCTS parameters.
Example
AT+MSCTS = ?
+MSCTS: (0-1)
OK
AT+MSCTS?
+MSCTS: 0
OK
AT+MSCTS = 1
OK
ATS102?
1
OK
Note: This means that by waking up, the CTS line will stay OFF and it can be activated by the
Wakeup IN Line interrupt only.
Error Handling Commands
+CMEE, Report Mobile Equipment Error
The Set command disables or enables the use of result code +CME ERROR: as an
indication of an error relating to the functionality of the G24-L. When enabled, G24-L-related
errors cause a +CME ERROR: final result code instead of the regular ERROR final result
code. Usually, ERROR is returned when the error is related to syntax, invalid parameters or
terminal functionality.
For all Accessory AT commands besides SMS commands, the +CMEE set command disables or
enables the use of result code +CME ERROR: as an indication of an error relating to the
functionality of the G24-L. When enabled, G24-L related errors cause a +CME ERROR:
final result code instead of the regular ERROR result code.
For all SMS AT commands that are derived from GSM 07.05, the +CMEE Set command disables
or enables the use of result code +CMS ERROR: as an indication of an error relating to the
functionality of the G24-L. When enabled, G24-L-related errors cause a +CMS ERROR:
final result code instead of the regular ERROR final result.
Table 3-138: +MSCTS Parameters
Description
0 In Normal Mode: The CTS is used for Flow Control
In Sleep mode: The CTS is inactive.
1
Wakeup In line is Active: The CTS is used for Flow Control.
Wakeup In line is Inactive: The CTS is inactive.
The default value is 0.