PIONEERPOS AT Commands G24-LC - Manual (Page 257)

Chapter 3: AT Commands Reference
April 15, 2008 G24-L AT Commands Reference Manual 3-193
Example
ATE?
001
OK
X, Result Code Selection and Call Progress Monitoring Control
This command defines the CONNECT result code format. It determines whether or not the
G24-L transmits particular result codes to the user. It also controls whether the G24-L verifies the
presence of dial tone when it first goes off-hook to begin dialing, and whether the engaged tone
(busy signal) detection is enabled.
The following table shows the X parameters.
Example
ATX?
000
OK
Command Type Syntax Response/Action Remarks
Set ATX OK
or:
+CME ERROR:
The Set command sets the result code
and call progress monitoring control.
Read ATX?
Test The Test command for X is not defined
by ITU, and therefore is not supported
by the G24-L. The G24-L returns an
error.
Table 3-130: X Parameters
Description
0 CONNECT result code given upon entering online data state:
Dial tone detection - Disabled
Busy detection - Disabled
1 CONNECT result code given upon entering online data state:
Dial tone detection - Disabled
Busy detection - Disabled
2 CONNECT result code given upon entering online data state:
Dial tone detection - Enabled
Busy detection - Disabled
3 CONNECT result code given upon entering online data state:
Dial tone detection - Disabled
Busy detection - Enabled
4 CONNECT result code given upon entering online data state:
Dial tone detection - Enabled
Busy detection - Enabled
The default value is 0.