PIONEERPOS AT Commands G24-LC - Manual (Page 228)

Audio
3-164 G24-L AT Commands Reference Manual April 15, 2008
The following diagram shows the audio paths:.
Figure 3-6: Audio Paths
Command
Type Syntax Response/Action Remarks
Set +MAPATH=
,
[,]
OK
or:
+CME ERROR:
The Set command sets the audio path
mode. The mode indicates which I/O
accessories are now active for the different
audio features. The field is
only used for outputs (direct=2).
Read +MAPATH? +MAPATH:1(mode
in),
+MAPATH:2(mode out),
,
[+MAPATH:2
(mode out),
,
[...]]
OK
The Read command returns the active
input audio accessory and the output
accessory for each feature.
Test +MAPATH=? +MAPATH: (list of
supported directions),(list
of supported
accessories),(list of
supported features
combinations)
OK
The Test command returns the supported
audio directions (input/output),
accessories and features.
H a nds e t M ic rophone
H e a ds e t M ic rophone
Voic e
H e a ds e t Spe a k e r
Voic e
H a nds e t Spe a k e r
A le rt/R inge r
A le rt Tra ns duc e r
H a nds e t M ic rophone
H e a ds e t M ic rophone
Input
• Voice
•
• Alert
• Ring
Features:
• Voice
• Key feedback
• Alert
• Ring
H eadset S peaker
H andset S peaker
A lert Transducer
Input voice
O utput