PIONEERPOS AT Commands G24-LC - Manual (Page 224)

Audio
3-160 G24-L AT Commands Reference Manual April 15, 2008
The following table shows the +CLVL parameters.
Example
AT+CLVL?
+CLVL: 7
OK
AT+CLVL=?
+CLVL: (0-7)
OK
AT+CLVL=3
OK
+CMUT, Mute/Unmute Currently Active Microphone Path
This command is used to mute/unmute the currently active microphone path by overriding the
current mute state.
The following table shows the +CMUT parameters.
Table 3-102: +CLVL Parameters
Description
0-7 Manufacturer-specific volume range. 0 is lowest volume (not mute).
The default value is 7 after flex.
Command Type Syntax Response/Action Remarks
Set +CMUT= OK
or:
+CME ERROR:
The Set command enables/disables
uplink voice muting during a voice
call.
Read +CMUT? +CMUT:
OK
The Read command returns the current
uplink voice mute/unmute state.
Test +CMUT=? +CMUT: (list of
supported s)
OK
The Test command returns the possible
values.
Table 3-103: +CMUT Parameters
Description
0 Unmute microphone path
1 Mute microphone path