PIONEERPOS AT Commands G24-LC - Manual (Page 204)

Hardware Information
3-140 G24-L AT Commands Reference Manual April 15, 2008
+MGGIND, GSM/GPRS Service Indicator
This command configures the service indicator line of pin 49 of the 70 pin connector to be GPRS
or GSM registration indicator.
The IO line (pin 49) function according to the current registration state (in service or not) of the
specific service indicator configuration.
Note: IO line (pin 49) outcome depends on +MCWAKE configuration.
The following table shows the +MGGIND parameters.
Example
AT+MGGIND=0
OK
AT+MGGIND?
OK
+MGGIND: 0
AT+MGGIND=1
OK
AT+MGGIND?
+MGGIND: 1
OK
AT+MGGIND=?
+MGGIND: (0-1)
OK
Command Type Syntax Response/Action
Set AT+MGGIND= OK
or:
+CME ERROR:
Read AT+ MGGIND ? +MGGIND:
OK
or:
+CME ERROR:
Test AT+ MGGIND =? +MGGIND: (list of supported
s)
OK
Table 3-91: +MGGIND Parameters
Description
0 GPRS registration indicator.
1 GSM registration indicator.