PIONEERPOS AT Commands G24-LC - Manual (Page 183)

Chapter 3: AT Commands Reference
April 15, 2008 G24-L AT Commands Reference Manual 3-119
+CREG, Network Registration Status
The following table shows the +CREG parameters.
Command Type Syntax Response/Action Remarks
Set AT+CREG= OK
or:
+CME ERROR:
The Set command controls the
presentation of an unsolicited result
code and the result of the Read
operation.
Read AT+CREG? +CREG:
,[,,]
OK
or:
+CME ERROR:
The Read command returns the status
of the result code presentation and
shows whether the network has
currently indicated the registration of
the G24-L. Location information
elements and are returned
only when =2 and the G24-L is
registered in the network.
Test AT+CREG=? +CREG: (list of
supported s)
OK
Table 3-76: +CREG Parameters
Description
0 Disables the network registration unsolicited result code.
1 Enables the network registration unsolicited result code +CREG: .
2 Enables the network registration and location information in unsolicited
reports and Read command +CREG:[,,]. The default is 0.
0 Not registered, and the ME is not currently searching for a new operator to
which to register.
1 Registered, home network.
2 Not registered, but the ME is currently searching for a new operator to
which to register.
3 Registration denied.
4 Unknown.
5 Registered,
roaming.
Two-byte location area code in hexadecimal format.
Two-byte cell ID in hexadecimal format.