PIONEERPOS AT Commands G24-LC - Manual (Page 173)

Chapter 3: AT Commands Reference
April 15, 2008 G24-L AT Commands Reference Manual 3-109
+CGSMS, Select Service for MO SMS Messages
This command handles the selection of the service or service preference used by the G24-L to
send mobile-originated SMS messages.
Note: This command is network dependent, which means that the network must support SMS
over GPRS.
The following table shows the +CGSMS parameters.
Example
AT+CGSMS=?
CGSMS:(0-3)
OK
AT+CGSMS?
CGSMS: 1
OK
Command
Type
Syntax Response/Action Remarks
Set +CGSMS=[] OK
+CME ERROR:
The Set command selects the service
or service preference used to send
SMS messages. The value that is set is
not retained after a power cycle.
Read +CGSMS? +CGSMS:
+CME ERROR:
The Read command displays the
current SMS service preference
setting.
Test +CGSMS=? +CGSMS: (list of
currently available
s)
+CME ERROR:
The Test command displays a list of
currently available s on the
network.
Table 3-69: +CGSMS Parameters
Description
Indicates the service or service preference to be used.
0
GPRS
1 Circuit switched (default)
2 GPRS preferred (use circuit switched if GPRS is not available)
3 Circuit switched preferred (use GPRS if circuit switched is not available)
Other values are reserved and will result in an ERROR response to the Set command.