PIONEERPOS AT Commands G24-LC - Manual (Page 132)

Phone Books and Clock
3-68 G24-L AT Commands Reference Manual April 15, 2008
The following table shows the +MDSI parameters.
Command Type Syntax Response/Action Remarks
Set +MDSI= When mode is 1 and
SIM was invalidated or
deactivated: [+MDSI:
, , text>, ]
OK
+CME ERROR:
The following is the available mode
values for the Set command.
= 1 - Defines that unsolicited
+MDSI messages will be sent to the
DTE. If the SIM card was invalidated
or deactivated, the current status will
be sent to the DTE.
= 0 - No unsolicited message
is sent to the DTE.
Read +MDSI? +MDSI:
OK
+CME ERROR:
The Read command queries the current
settings for
Test +MDSI=? +MDSI: (list of
supported s)
OK
+CME ERROR:
The Test command returns the possible
values.
Table 3-38: +MDSI Parameters
Description
0 Unsolicited indications off
1 Unsolicited indications on
, text> 0 "DEACTIVATE". SIM deactivate request was sent with
1 "GSM". Invalidate SIM for GSM services was sent with
2 "GPRS". Invalidate SIM for GPRS services was sent with
,
and related to = 0 ("DEACTIVATE"):
1 "Bad SIM"
and related to = 1 ("GSM") and = 2 ("GPRS"):
0
"No reject cause"
2 "IMSI unknown in HLR"
3 "Illegal MS"
4 "IMSI unknown in VLR"
6 "Illegal ME"
7 "GPRS service not allowed"
8 "GPRS and non-GPRS services not allowed"
9 "MS identity cannot be derived by the network"
11 "PLMN not allowed"
12 "Location area not allowed"
13 "Roaming not allowed in this location area"
14 "GPRS services not allowed in this PLMN"
240 "Location update failure"
241 "Combined LU failure"
242 "Authentication and ciphering reject"
243 "Authentication reject"
244 "Attach failure"