PIONEERPOS AT Commands G24-LC - Manual (Page 117)

Chapter 3: AT Commands Reference
April 15, 2008 G24-L AT Commands Reference Manual 3-53
+CUSD, Unstructured Supplementary Service Data
This command allows control of Unstructured Supplementary Service Data (USSD), according to
GSM 02.90. Mobile-initiated operations are supported.
The following table shows the +CUSD parameters.
Command
Type
Syntax Response/Action Remarks
Set +CUSD=[,] OK
+CME ERROR:
The Set command enables/disables the
display of the following unsolicited
result code, +CUSD: [,] (the
USSD response from the network), to
the TE. The new value is not retained
after a power cycle.
Read +CUSD? +CUSD:
+CME ERROR:
The Read command displays the
current value of .
Test +CUSD=? +CUSD: (list of
supported s)
+CME ERROR:
The Test command displays the
supported values of .
Table 3-29: +CUSD Parameters
Description
Sets/displays the result code presentation status of the G24-L.
0
Disable (default)
1 Enable
2 Cancel session
A USSD string that, when included, causes a mobile-initiated USSD string or
response USSD string to be sent to the network. The response USSD string is returned
in a subsequent unsolicited +CUSD result code.
starts with either "*" or "#". The maximum length is 200 characters, based on
+CSCS.
When is not included, the network is not queried.
Whether further user action is required.
0
No further user action required (either network-initiated USSD-Notify, or no
further information needed after a mobile-initiated operation)
1
Further user action required (either network-initiated USSD-Request, or
further information needed after a mobile-initiated operation
2
USSD terminated by the network (the reason for the termination is indicated
by the index, as described in Table Note: )
3 Other local client has responded
4 Operation not supported
5 Network time out