Promise Technology 66 Pro User Manual
Page 42
SuperTrak66™ User's Manual
Chapter 3
- 31 -
Figure 16: Controller configuration screen
This screen allows you to modify the “Halt On Error” option (enable/disable) by
pressing the spacebar. “Halt On Error” is enabled if you want the system to halt
processing during bootup if the SuperTrak66 BIOS determines that there is an
array error. All other information in the System Resources Configuration section is
for display only. The information presented here is as follows:
Driver Version
Shows the driver software version of the IxWorks operating system,
Promise Hardware Driver Module (HDM), and Promise Intermediate
Software Module (ISM).
Number of Channels
Shows the number of channels attached to the SuperTrak66 controller
which may be used to connect one drive each for use in RAID arrays.
Processor Memory
Shows the size of the SIMM plugged into the SuperTrak66 controller card.