Promise Technology 66 Pro - Manual (Page 105)

SuperTrak66™ User's Manual Chapter 5
- 94 -
To Stop Rebuild
1) To halt the Rebuild process, right-click the Array # again.
2) The pull-down menu will appear showi ng the Stop Rebuild option as shown
below (see below).
3) Once "Stop Rebuild" is selected, you will be asked to verify "Cancel Rebuild?"
4) Click "OK" to Stop or "No" to continue Rebuild.
NOTE: You may also start/continue, pause, or stop the process using the Toolbar
icons.
Figure 75: Stop Rebuild pull-down
Array Synchronization
Synchronization is a periodic maintenance procedure for Mirroring (RAID 1, 0+1, 3,
and 5) arrays to maintain data consistency on all mirrored drives. In operation,
array synchronization compares data on the mirrored drives for any differences. If
there are differences detected, data from the primary drive(s) is automatically
copied to the secondary drive(s). This assures that all mirrored drives will contain
the exact information.
NOTE: Users may choose to schedule synchronization during unattended, off -peak
hours (see page 74).
1) To manually synchronize drives from SuperCheck, choose the icon of the
mirrored Array in Tree View.
2) Right-click the array icon, and choose “Synchronize” from the pull-down menu
(see Figure 76) or select "Array" from pull down menu at top and choose
"Synchronize" from the pull-down menu. This will initiate the process.
3) You will be returned to the main SuperCheck screen. A progress bar will
display at the bottom of the window.