beautypg.com

Promise Technology 66 Pro User Manual

Page 21

background image

SuperTrak66™ User's Manual

Chapter 2

- 10 -

5) Highlight “TCP/IP Protocol” from the listbox, then click on the “OK”

button.

6) Windows NT will proceed to install the TCP/IP protocol stack.

7) Click on the “Configure” button.

8) Enter the network IP address. If you do not know the IP address,

cont act your network administrator. An incorrectly configured IP may
result in network conflicts.

9) Enter the Subnet Mask (generally 255.255.255.0, but contact your

network administrator if you are uncertain.)

10) Save all the settings, shut down, and restart the server.

11) You may test the server response by issuing a “ping” command from

the command prompt shell on another workstation on the LAN. (“ping
xxx.xxx.xxx.xxx” where “xxx” corresponds to the IP address you
configured the server for). A reply will be received if both systems are
configured correctly.

NOTE: For further information on IP addressing, and TCP/IP configuration,
consult the Windows NT documentation.