Supertrak66 technical specifications – Promise Technology 66 Pro User Manual
Page 135
![background image](/manuals/181108/135/background.png)
SuperTrak66™ User's Manual
Appendix B
B-1
SuperTrak66 Technical Specifications
Performance-Related Features
•
True hardware-based RAID
•
Single IRQ per RAID I/O
•
Intelligent cache dynamically configures itself
•
Support for up to 128MB (minimum of 8MB required) of EDO RAM in one 72
pin SIMM socket
•
Microprocessor offloads tasks to reduce system CPU utilization
•
User-configurable cache parameters for each array: dirty threshold, write policy,
read ahead policy and flush policy
•
User-configurable RAID stripe sizing allows controller to optimize operations for
operating systems and applications
•
User-configurable rebuild priority. Allows the user to keep RAID performance
high while performing data rebuilds
•
Multi-threaded command processing and disk operations
•
Supports Tagged Command Queuing for optimal disk performance
•
Advanced load balancing and elevator seek for optimal disk performance
•
Hardware scatter gather DMA engine reduces CPU overhead
•
Intelligent algorithm to optimize RAID 5 writes
Data Protection Features
•
Support for RAID levels 0, 1, 0+1, 3, 5 and Spanning
•
Meets all of the RAID Advisory Board’s standards for RAID levels
•
Automatic sector re-mapping allows defective hard disk sectors to be re-
mapped with data recovery
•
Automatic failed drive detection and transparent disk drive rebuild
•
Onboard buzzer sound audible alarms in the event of failure
•
Supports S.M.A.R.T. capable drives for predictive failure analysis messaging
through SuperCheck GUI
•
Hot swap capability
•
Hot spare capability
•
Configuration is stored on all disks in the array. This allows configuration to be
restored to a new controller in case of controller failure
Host Interface
•
On board 32-bit Intel i960RD RISC microprocessor
•
I
2
O version 1.5 compliant
•
Supports up to 33MHz PCI bus speed
•
Supports up to 133MB per second burst data transfer rate across PCI bus
•
Provides 32-bit PCI bus mastering with 0 wait states.
•
PCI Local Bus version 2.1 compliant
•
Onboard 64K Flash BIOS
•
Firmware Flash EEPROM
•
NVRAM for error log for fast recovery