Kodak I7300 - Manual (Page 78)

A-61133 March 2003 4-7
7. Preset. The Preset option is used when the image address begins
at something other than one (1).
•
If Set to First image address is enabled, the preset image
address will be assigned to the first image mark on the film.
•
If Set to First image address is disabled, the preset image
address assigned to the first image mark on the film will be
incremented by one from the image address that was entered.
NOTES regarding Preset:
•
The scanner will start counting at 1 (or 1.0 or 1.0.0) unless a
preset image address is specified.
•
The A and B presets remain in memory until the film is refiled.
•
The preset image address that is specified will be affected by the
Preset parameter in Application setup.
−
If the Preset parameter is enabled, the specified Channel A
preset will be assigned to the first image mark in Channel A.
The specified Channel B preset will be assigned to the last
image mark in Channel B.
−
If the Preset parameter is disabled, the specified Channel A
preset will be incremented by one and that value will be
assigned to the first image mark in Channel A. The specified
Channel B preset will be decremented by one and that value
will be assigned to the last image mark in Channel B.
8. Odometer Scale. Setting up an odometer scale allows you to
search film by odometer units rather than image marks. To set this
value, select Setup… to display the Odometer Scale dialog box.
See the section entitled, “Setting the odometer scale” later in this
chapter for more information.