Kohler Command Pro CV980 - Manual (Page 91)

8.15
Section 8
Disassembly
8
Remove Lifter Feed Chamber Cover and
Gaskets
ȱ ŗǯȱ Ž–˜ŸŽȱ‘Žȱ‘›ŽŽȱœŒ›Ž œȱœŽŒž›’—ȱ‘Žȱ•’ĞŽ›ȱŽŽȱ
chamber cover, and gaskets. Carefully separate
‘Žȱ™Š›œȱ›˜–ȱ‘ŽȱŒ›Š—”ŒŠœŽǯȱŽŽȱ’ž›ŽȱŞȬŜŖǯ
Figure 8-60. Removing Lifter Feed Chamber Cover
Components.
Remove Flywheel and PTO End Oil Seals
1. Remove the oil seals from the crankcase and oil
™Š—ȱžœ’—ȱŠȱœŽŠ•ȱ™ž••Ž›ǯȱȱŽŽȱ’ž›ŽȱŞȬŜŗǯ
Figure 8-61. Removing Oil Seals.
Removal of Main Bearings
DZȱ •¢ ‘ŽŽ•ȱŠ—ȱȱœ’Žȱ–Š’—ȱ‹ŽŠ›’—œȱȱ
should only be removed if replacement
is required due to wear. If removal is
performed, use a press and support the
adjacent cast surface around the bearing
̊—Žȱ ‘Ž—ȱ™Ž›˜›–’—ǯȱDo not press
ŠŠ’—œȱ˜›ȱœž™™˜›ȱ‹¢ȱ‘ŽȱŠœ”ŽȦ˜žŽ›ȱ
™Ž›’–ŽŽ›ȱœž›ŠŒŽǯȱŽŽȱ’ž›ŽȱŞȬŜŘǯ
Figure 8-62. Support Surface Details.
Cover Gasket
Screws
Support
This Surface