Kohler Command Pro CV980 User Manual
Page 88
8.12
Section 8
Disassembly
Figure 8-47. Valve Stem Seals.
NOTE: These engines use valve stem seals on
the intake and exhaust valves. Use a
new seal whenever valves are removed,
or if the seal is deteriorated in any way.
Never reuse an old seal.
4. Repeat the above procedure for the other cylinder
head. Do not interchange parts from one cylinder
head to the other.
Remove Breather Assembly
ȱ ŗǯȱ ȱȱȱ¡ȱĚȱ ȱȱȱȱ
breather assembly, and gasket to the crankcase.
2. Carefully break the gasket seal and remove the
ȱȱęǯȱȱȱ¢ȱȱȱȱ
surfaces as it could cause damage resulting in
leaks. Note the assembly and orientation of parts.
ȱȱŞȬŚŞȱȱŞȬŚşǯ
Figure 8-48. Removing Breather Assembly.
Figure 8-49. Removing Breather Filter.
Remove Oil Pan Assembly
ȱ ŗǯȱ ȱȱȱ¡ǯȱĚȱ ȱȱ
ȱȱȱȱȱǯȱȱȱŞȬśŖǯ
Figure 8-50. Removing Oil Pan Screws.
2. Locate the two protruding tabs on the oil pan.
Carefully tap to break the gasket seal. Do not pry
on the sealing surfaces as this could cause leaks.
Separate the oil pan from the crankcase. See
ȱŞȬśŗȱȱŞȬśŘǯȱȱȱȱǯ
Figure 8-51. Location of Protruding Tabs.
Valve Stem Seals
Breather
Gasket
Tabs
Filter