Kohler Command Pro CV980 - Manual (Page 89)

8.13
Section 8
Disassembly
8
Figure 8-52. Removing Oil Pan.
Oil Pump Assembly
The oil pump is mounted to the inside of the oil pan.
If service is required, refer to the service procedures
ž—Ž›ȱȁȁ’•ȱž–™ȱœœŽ–‹•¢ȂȂȱ’—ȱŽŒ’˜—ȱşǯ
Remove Camshaft
ȱ ŗǯȱ Ž–˜ŸŽȱ‘ŽȱŒŠ–œ‘ŠĞȱŠ—ȱœ‘’–ȱǻ’ȱžœŽǼǯȱŽŽȱ
’ž›ŽȱŞȬśřǯ
Figure 8-53. Removing Camshaft.
Remove Connecting Rods with Pistons
and Rings
ŗǯȱ Ž–˜ŸŽȱ‘Žȱ ˜ȱ‘Ž¡ȱ̊—ŽȱœŒ›Ž œȱœŽŒž›’—ȱ‘Žȱ
closest connecting rod end cap. Remove the end
ŒŠ™ǯȱŽŽȱ’ž›ŽœȱŞȬśŚȱŠ—ȱŞȬśśǯ
Figure 8-54. Removing Connecting Rod Screws.
NOTE: If a carbon ridge is present at the top
of either cylinder bore, use a ridge
reamer tool to remove the ridge before
ŠĴŽ–™’—ȱ˜ȱ›Ž–˜ŸŽȱ‘Žȱ™’œ˜—ǯ
Figure 8-55 Remove Connecting Rod Caps.
NOTE: The cylinders are numbered on the
crankcase. Use the numbers to mark
each end cap, connecting rod and piston
for reassembly. Do not mix end caps and
connecting rods.