Kohler Command Pro CV980 - Manual (Page 85)

8.9
Section 8
Disassembly
8
Wiring
Harness
Molded
Clips
2. Remove the mounting screws securing the
›ŽŒ’ꎛȬ›Žž•Š˜›ȱ˜ȱ‘Žȱ‹ŠŒ”’—ȱœ‘›˜žȱ
assembly. Note the location of the ground lead.
ȱ‘Žȱ›ŽŒ’ꎛȬ›Žž•Š˜›ȱ’œȱ—˜ȱ‹Ž’—ȱ›Ž™•ŠŒŽǰȱ
it may remain mounted to the backing shroud
ŠœœŽ–‹•¢ǯȱŽŽȱ’ž›ŽȱŞȬřřǯ
)LJXUH5HFWL¿HU5HJXODWRU'HWDLOV
3. Remove the two screws securing the stator to the
crankcase and carefully separate the stator wires
›˜–ȱ‘Žȱ–˜•ŽȱŒ•’™œǯȱŽŽȱ’ž›ŽȱŞȬřŚǯ
Figure 8-34. Removing Stator.
4. Unhook the wiring harness from the molded
Œ•’™œȱ’ȱ‹Ž’—ȱœŽ›Ÿ’ŒŽȱœŽ™Š›ŠŽ•¢ǯȱŽŽȱ’ž›ŽȱŞȬřśǯ
Figure 8-35. Removng Wiring Harness.
Remove Backing Shroud Assembly
1. Remove the four screws securing the backing
shroud assembly to the crankcase. See Figure
ŞȬřŜǯ
Figure 8-36. Removing Backing Shroud Mounting
Screws.
Remove Spark Plugs
1. Remove the spark plug from each cylinder head.
Figure 8-37. Removing Spark Plugs.
Mounting
Screws
Molded
Clips
Ground
Lead
Plug
5HFWL¿HU
Regulator
Backing Shroud
Assembly
Screws