Kohler Command Pro CV980 - Manual (Page 82)

8.6
Section 8
Disassembly
NOTE: New clamps are recommended any time
disassembly is performed, or if clamps
have been loosened (expanded) several
times.
)LJXUH5HPRYLQJ9DOOH\%DIÀHV
2. Remove the four screws securing each of the
˜žŽ›ȱŒ¢•’—Ž›ȱ‹ŠĝŽœȱ’—ȱ™•ŠŒŽǯȱŽŽȱ’ž›ŽȱŞȬŘŖǯ
)LJXUH5HPRYLQJ2XWHU&\OLQGHU%DIÀHV
ȱ řǯȱ Ž–˜ŸŽȱ‘Žȱ˜ž›ȱ‘Ž¡ȱ̊—ŽȱœŒ›Ž œȱœŽŒž›’—ȱ‘Žȱ
intake manifold to the cylinder heads. Cut any
wire ties securing wiring.
4. Remove the intake manifold and gaskets. See
’ž›ŽȱŞȬŘŗǯ
Figure 8-21. Removing Intake Manifold.
Remove Oil Cooler
1. Remove the two oil cooler mounting screws. Do
—˜ȱ•˜œŽȱŠ—¢ȱ Šœ‘Ž›œȱǻ’ȱžœŽǼǯȱŽŽȱ’ž›ŽȱŞȬŘŘǯ
Figure 8-22. Removing Oil Cooler Mounting
Screws.
2. Loosen the clamps and disconnect each of the
‘˜œŽœȱ›˜–ȱ‘Žȱ˜’•ȱŒ˜˜•Ž›ǯȱŽŽȱ’ž›ŽȱŞȬŘřǯ
Figure 8-23. Disconnecting Hoses From Oil Cooler.
Remove Oil Filter Housing
ŗǯȱ Ž–˜ŸŽȱ‘ŽȱœŒ›Ž ȱœŽŒž›’—ȱ‘Žȱ˜’•ȱꕝŽ›ȱ‘˜žœ’—ȱ
Š—ȱ’—’Ÿ’žŠ•ȱȬ’—œȱ˜ȱ‘ŽȱŒ›Š—”ŒŠœŽǰȱ‘Ž—ȱ
ŒŠ›Žž••¢ȱœŽ™Š›ŠŽȱ‘Žȱ™Š›œǯȱŽŽȱ’ž›ŽȱŞȬŘŚǯ
DZȱ ž›‘Ž›ȱ’œŠœœŽ–‹•¢ȱ˜ȱ‘Žȱ˜’•ȱꕝŽ›ȱ
housing assembly is not necessary
unless being serviced individually.
Follow Substeps a, b, and c.
Mounting
Screw Locations
Valley
%DIÀH
Mounting
Locations
Mounting
Locations