Kodak NOVAJET 700 User Manual
Page 85
NovaJet 500/630/700 Series Service Manual
MAINTENANCE
Maintenance
3-43
4. Obtain the latest firmware revision, unpack the file and
launch the “XXX Firmware Utility.” File names may be
different then that listed above.
Click on “File”
Click on “Preferences”
Select the appropriate port that your printer is connected to
(either Modem or Printer.)
Drag and Drop the XXXX.ROM file (or the latest version)
into the “Spool Folder”.
Wait approximately 20 to 40 seconds later until you hear a
SINGLE beep, indicating the download was successful. You
may encounter a set of double beeps shortly after sending
the firmware file, but you must wait until you hear the
SINGLE beep.
5. After hearing the single beep, remove power from printer for
15-20 seconds. Apply power to the printer. The printer
should initialize properly. Verify firmware revision by
sequencing through Utility Menu - Service Menu -
About menu. Verify firmware has been incorporated.
If the firmware download is not successful you may hear
more than 1 beep or complete silence. Check port
connections and return to step 4.