Remove extra memory (simm) – Kodak NOVAJET 700 User Manual
Page 122
5-10
Assembly\Disassembly
NovaJet 500/630/700 Series Service Manual
Remove Extra Memory (SIMM)
Integrated circuits may become weakened or damaged by
electrical discharge. Do not touch or work near integrated
circuits without wearing an ESD wrist strap.
1. Perform steps 1 through 9 of the Remove the Left, Top, and Right
Covers procedure to remove the Top and Right Covers.
Figure 5-6. Extra Memory (SIMM) Installation/Removal.
2. The SIMM slots are at a 90
°
angle from the main circuit board.
Facing the top of the SIMM, push the side clips gently to the outside
(away from the SIMM) then push the top of the SIMM module
towards the left side of the printer until the SIMM becomes free of
the side clips. Lift up and pull the SIMM out, being careful not to
damage the fingers on the top. See Figure 5-6.