Kodak NOVAJET 700 - Manual (Page 147)

NovaJet 500/630/700 Series Service Manual
ASSEMBL
Y
/
DISASSEMBL
Y
Assembly\Disassembly 5-35
CARRIAGE
BUSHING
LATCH
Figure 5-20. Carriage Bushing Removal.
2. Use a flat tip screwdriver to push up on the latch which holds the
Carriage Bushing in place. See Figure 5-20.
3. Pull the Carriage Bushing out of the Carriage Assembly.
4. Repeat Steps 2 and 3 for the other Carriage Bushing.
TABS
Figure 5-21. Carriage Bushing Installation.
5. Orient the new Bushing as shown in Figure 5-21 so that the
metal tab on top of the Bushing goes into the Carriage Assembly
first.
6. Push the Bushings in until they snap into place.
7. Perform the Reinstall the Carriage Assembly, Carriage Belt, and
the Frame Tensioner procedures to reinstall the Carriage
Assembly if Carriage was removed.