Kodak NOVAJET 700 - Manual (Page 162)

5-50 Assembly\Disassembly
NovaJet 500/630/700 Series Service Manual
11. Reinsert the Service Station.
12. Reinstall the Right Sideplate using a #2 Phillips screwdriver.
Ensure that all cables from inside the Platen are exiting out of the
large hole in the Sideplate.
13. Reinstall the Power Supply Bracket using four screws and a #2
Phillips screwdriver.
14. Perform steps 5 through 14 of the procedures to reconnect the
MPCB.
15. Reinstall the left Foam Block.
16. Reinstall the Left Sideplate Assembly using a #2 Phillips
screwdriver.
17. Perform steps 1 through 4 of the Install the Ink Delivery System
procedures to reinstall the Ink Delivery System.
18. Perform the Install Left, Top, and Right Covers procedures to
install the Left, Top, and Right Covers.
Remove the Media Take-Up and Feed Sensor
Brackets and Sensors
NOTE
The sensors for the media Take-Up and Feed Assembly
are identical, but the brackets that they mount to have
distinct differences. The top bracket has an additional
extended arm attached to help in directing the media from
blocking the sensor’s beam path. Ensure that the bracket
is being replaced with the correct bracket.
1. Remove all media and media rollers from the printer.
2. Disconnect the sensor leads from the printers leg assembly by
squeezing the sides of the connector to release the quick disconnect
latches.
3. With a pair of wire cutters, cut the wire tie wraps (see Figure 5-28)
that is securing the sensor leads to the sensor bracket.