Kodak NOVAJET 700 - Manual (Page 167)

NovaJet 500/630/700 Series Service Manual
ASSEMBL
Y
/
DISASSEMBL
Y
Assembly\Disassembly 5-55
4. Remove the air filter from the fan to be removed by squeezing the
tabs on the filter housing to release the housing off the fan.
5. Remove the four bolts securing the back bracket (the one with the
positioning bolts on the bottom) to both of the side plates.
6. Pull the back bracket away from the fans to gain access to the
faulty fan. Carefully pull the fan away from the front bracket until
access is gained to reach the electrical connector.
7. Disconnect the connector to the fan.
Install the Media Drying Fans
1. Reconnect the electrical connection to the fan. Push the connector
and wires into the bracket so the fan can be seated correctly on the
bracket.
2. Carefully orient all the fans so that the back bracket can be
installed correctly. Secure the back bracket to the side plates.
3. Install the air filter and air filter housing.
4. Lay the entire assembly onto the support brackets on the printer.
Ensure that the cable connector is on the right side of the printer as
it is installed.
5. Reattach the positioning wingnut on the left side of the assembly.
6. Attach the wire connector to the leg harness plug. Push connector
in until firmly seated.