Kodak NOVAJET 700 - Manual (Page 135)

NovaJet 500/630/700 Series Service Manual
ASSEMBL
Y
/
DISASSEMBL
Y
Assembly\Disassembly 5-23
4. With a flathead screwdriver, press the Carriage Cover (p/o the Ink
Delivery System) tab located in the upper slot on the left side of
the Carriage Assembly. See Figure 5-12. Lift up on the front left
side of the Carriage Cover until it comes part way off of the
Carriage Assembly. Then lift up on the front right side of the
Carriage Cover and move the Carriage Cover slightly to the left so
that the back of it clears the Back Support Bracket.
5. Disconnect the Ink Delivery System Bracket from the Left
Sideplate using a #2 Phillips screwdriver.
6. Carefully slide the Ink Delivery System out of the printer.
Install the Ink Delivery System
1. Secure the Ink Delivery System Bracket to the Left Sideplate
using two screws.
2. Position the Ink Delivery System into the Support Bracket so that
it is easier to orient the Carriage Cover portion of the system over
the Carriage for reinstallation.
3. Reattach the Chain Support Bracket to the Rear Support Bracket.
4. Position the Carriage Cover over the Carriage Assembly. Depress
the two tabs on each side of the Cover and lower the Assembly
onto the Carriage until it snaps into place.
5. Move the Carriage Assembly over the Chain Support Bracket and
adjust the position of the Chain Support Bracket to ensure that
there is a 0.10 inch clearance between the top of the Chain
Support Bracket and the bottom of the chain assembly that is
attached to the Carriage Cover on the Carriage Assembly. See
Figure 5-13. Perform this procedure on both screws of the Chain
Support Bracket.