beautypg.com

Kodak NOVAJET 700 User Manual

Page 155

background image

NovaJet 500/630/700 Series Service Manual

ASSEMBL

Y

/

DISASSEMBL

Y

Assembly\Disassembly

5-43

Install the Y-Arm Assembly, Pinch Rollers, Slide

Shaft, and Auto-Load Sensor

1. Install the Auto-Load Sensor Assembly into the back part of the

Y-Arm Bracket using a #1 Phillips screwdriver. Torque to 6 in-

lbs.

2. Route the Load Sensor wires through the four wire clamps on the

back part of the Y-Arm Bracket.

3. Install the Slide Shaft and two supports to the Y-Arm Assembly

using four screws. Torque to 8 in-lbs.

4. Insert the back compression spring onto the shaft of the pinch

roller and push the back of the shaft through the back of the Y-

Arm Assembly. Install the C clamp around the shaft of the pinch

roller.

5. While compressing the forward pinch roller spring with a

screwdriver (or other flat object), position the pinch roller onto the

Y-Arm Assembly until the forward spring is located under the

hole in the Slide Shaft. Release the spring and verify that the

spring enters the hole in the Slide Shaft and that no kinks are

present in the spring.

6. Perform steps 4 and 5 for all pinch rollers.

7. Using a #2 Phillips screwdriver, secure the Y-Arm Assembly to

the Platen using seven screws. Torque to 15 in-lbs.

8. Perform the Install the Stabilizer Bracket and Encoder Strip

procedures to install the Stabilizer Bracket and Encoder Strip.

9. Perform the Install the Carriage Assembly, Carriage Belt, and

the Frame Tensioner Procedures to install the Carriage

Assembly, Carriage Belt, and the Frame Tensioner.

10. Perform the Install the Trailing Cable Assembly procedures to

install the Trailing Cable Assembly.

11. Perform the Install the Ink Delivery System procedures to install

the Ink Delivery System.

This manual is related to the following products: