Kodak NOVAJET 700 - Manual (Page 118)

5-6 Assembly\Disassembly
NovaJet 500/630/700 Series Service Manual
Install the Left, Top, and Right Covers
To install the Left Cover Assembly:
1. Position the Left Cover Assembly over the Left Baseplate and while
depressing the retracting stop assembly on the Support Bracket,
lower the Left Cover into position onto the Left Baseplate. Release
the retracting stop assembly.
Applying too much torque to the lower screws can cause
the mounts for the standoffs on the cover to break, requir-
ing a replacement of the cover.
2. Using a #2 Phillips screwdriver, secure the Left Cover with two
screws located on the right side (torque to 15 in-lbs) and two located
under the baseplate (torque to 8 in-lbs).
3. Reinstall the ink reservoirs and reservoir door.
To install the Right Cover Assembly:
4. Position and hold the Right Cover Assembly over the Right
Baseplate and reconnect the Display Power Converter cable to J10
on the MPCB.
5. Reconnect the Display data ribbon cable to J12 on the MPCB.
6. Reconnect the Keypad flex cable to J13 on the MPCB. Ensure that
the caution label on the flex cable is facing the SIMM slots.
7. While depressing the retracting stop assembly on the Support
Bracket, lower the Right Cover Assembly into position onto the
Right Baseplate. Release the retracting stop assembly.