Kodak NOVAJET 700 - Manual (Page 61)

NovaJet 500/630/700 Series Service Manual
MAINTENANCE
Maintenance 3-19
The Slide Shaft is set to 1.418” (36cm) from the top of the Slide Shaft to
the Platen surface for the NovaJet 500, 630 and 700 series printers.
The normal operating range for the height of the Slide Shaft is between
1.390” (35.3cm) to 1.440” (36.6cm).
The NovaJet 505 Slide Shaft is set to 1.478” (37.5cm) from the top of
the Slide Shaft to the Platen surface. The normal operating range for
this height of the Slide Shaft is between 1.471” (37.4cm) to 1.483”
(37.4cm).
You will need the following:
· Height Gauge Kit Assembly
· 1/4" open and box end wrench (.110” thick)
Height Gauge (Alignment) Kit Contents are:
Dial Gauge Micrometer
Modified Novajet Cartridge for newer products
Modified Novajet 4/Pro/Pro 50 Cartridge - Not Used
Platen/Carriage Shaft Mounting Block
Calibration Jo Block (1.434”) - Not used
Plastic Gauge Card (0.011”) - Not used
There are two basic measurements that are to be made using
this kit (ensure power is off prior to performing these procedures):
1. Slide Shaft Profile Adjustment
2. Carriage (Cartridge) Head Height Setting
1. Connect the dial gauge micrometer to the Shaft mounting
block as shown in Figure 3-11.
ZERO
GAUGE
SHAFT
MOUNTING
BLOCK
TIGHTEN SET
SCREW (NOT
SHOWN)
Figure 3-11. Dial Gauge Micrometer Assembly.