Kodak NOVAJET 700 - Manual (Page 152)

5-40 Assembly\Disassembly
NovaJet 500/630/700 Series Service Manual
Install the Stabilizer Bracket and Encoder Strip
1. Install the Stabilizer Bracket Assembly (with Encoder Strip and
Trailing Cable) onto the Y-Arm Assembly using the four alignment
Allen screws and washers. Hand tighten only.
2. Install the Support Bracket onto the Stabilizer Bracket Assembly by
placing the Support Bracket onto the Stabilizer Bracket with a
slight forward tilt.
3. Perform the Install the Carriage Assembly, Carriage Belt, and the
Frame Tensioner Procedures to install the Carriage Assembly,
Carriage Belt, and the Frame Tensioner.
4. Perform steps 2 through 7 of the Install the Trailing Cable
Assembly procedures to finish installing the Trailing Cable
Assembly.
5. Perform the Install the Ink Delivery System procedures to install
the Ink Delivery System.
6. Perform the Install the Left, Top, and Right Covers procedures to
install the Left, Top and Right Covers.
7. Perform the Head Height Adjustment procedures found in Chapter
3 of this service manual.
Remove the Y-Arm Assembly, Pinch Rollers, Slide
Shaft, and Auto-Load Sensor
1. Perform steps 1 through 13 of the Remove the Left, Top, and Right
Covers procedures to remove the Left, Top and Right Covers.
2. Perform steps 2 through 6 of the Remove the Ink Delivery System
procedures to remove the Ink Delivery System.
3. Perform the Remove the Carriage Assembly, Carriage Belt, and the
Frame Tensioner procedures to remove the Carriage Assembly from
the Slide Shaft.