Kodak NOVAJET 700 - Manual (Page 139)

NovaJet 500/630/700 Series Service Manual
ASSEMBL
Y
/
DISASSEMBL
Y
Assembly\Disassembly 5-27
11. To disengage the Carriage Belt from the Belt Clamp, push the
Carriage Belt away from the left post of the Belt Clamp and gently
lift up until the bottom edge of the Carriage Belt clears the top of
the left post.
12. Push the Carriage Belt away from the right post of the Belt
Clamp and gently lift up to finish removing the Carriage Belt
from the Belt Clamp.
Failure to use an approved antistatic bag for storage or
shipment may cause damage to the MPCB and affect
the Warranty.
13. Place the Carriage Assembly in an ESD (antistatic) bag in
preparation for shipment to ENCAD for replacement or repair, or
if it is to be stored for repair at your facility.
Install the Carriage Assembly, Carriage Belt, and
the Frame Tensioner
1. To install the Belt onto the Carriage Assembly, the “bumps” on
the belt (where the ends of the belt are joined together to make the
belt continuous) must be positioned between the left and right
posts of the Belt Clamp. See Figure 5-16.
2. Slide the Carriage Belt between the right post and the middle post
and guide it down into the Belt Clamp. Then slide the Carriage
Belt between the left post and the middle post and finish placing
the Carriage Belt into the Belt Clamp.
3. Check the position of the Carriage Belt to make sure it matches
Figure 5-16.
4. Make sure the left end of the Trailing Cable extends out beyond
the left end of the Trailing Cable Support Assembly.