Kodak NOVAJET 700 - Manual (Page 145)

NovaJet 500/630/700 Series Service Manual
ASSEMBL
Y
/
DISASSEMBL
Y
Assembly\Disassembly 5-33
c. Push down on the plastic clip and at the same time push
down on the Encoder until the plastic pieces on each side of the
Encoder clear the ridges which hold it in place. Then pull it
straight out.
Install the Paper Sensor or the Encoder Sensor
Figure 5-19. Paper and Encoder Sensor Installation.
1. To install the Paper Sensor:
a. Turn the Carriage Assembly so that the bottom side of it is
facing up.
b. Route the flex on the Paper Sensor through the slot in the
Carriage Assembly. Make sure the flex cable goes all the way
through and does not curl under the Carriage PCB.
c. Grasp the Paper Sensor between thumb and index finger and
guide the sides of the board into the grooves on each side of the
opening. See Figure 5-19.
d. Push the Paper Sensor board down into the Carriage
Assembly until it snaps firmly into place.