Kodak NOVAJET 700 - Manual (Page 166)

5-54 Assembly\Disassembly
NovaJet 500/630/700 Series Service Manual
Install the Media Take-Up and Feed Motors
1. Using a #1 Phillips screwdriver, install the three screws, washers,
and lock washers that secures the motor to the motor mount.
2. Install the motor gear to the motor. Secure with a C clamp.
3. Insert the motor, motor mount, and motor gear subassembly into
the back of the Cradle Idler. Tilt the subassembly slightly while
installing to align the motor gear with the opening on the top of the
Cradle Idler.
4. Screw in the screw and washer that secures the motor mount to the
Cradle Idler.
5. Attach the tension spring to the post on the Cradle Idler.
6. Position the Cradle Idler assembly in front of the hole in the leg
assembly. Attach the wire connectors to the motor (red to the
positive terminal, black to the negative terminal.)
7. Insert the Cradle Idler Assembly into the leg and secure with four
screws.
Remove the Media Drying Fans
1. On the left side of the drying fan assembly is a black wingnut used
to adjust the position of the fan assembly. Remove the black
wingnut.
2. Disconnect the drying fan assembly leads from the printers leg
assembly by squeezing the sides of the connector to release the
quick disconnect latches.
3. Lift the entire drying fan assembly off of the printer.